Rough Country 875.20 User Manual

Page 7

22. Cut the control arm pocket as shown in Photo 20 & Photo 21. Paint and smooth cut area with grinder if needed.

23. Install new front cross-member using 9/16x 4 1/2”bolts.See Photo 22. Do not tighten at this time. NOTE: Due to

factory differences in the frame mounting points, it may be necessary to grind the top of the new cross members to
create clearance to slide all the way up in the frame to align the mounting holes. See Photo 23.

24. Install differential using a floor jack or jack stands using stock diff hardware in the new cross member. Do not tighten

at this time. See Photo 24. (4WD ONLY)

25. Install rear cross-member with two supplied 9/16 x 4 1/2” bolts/washers. Passenger side is shown in Photo 25.

NOTE: Due to factory differences in the frame mounting points, it may be necessary to grind the top of the new
cross members to create clearance to slide all the way up in the frame to align the mounting holes and it may be
necessary to grinds down the raised steps on the inside portion of the mounting pockets.

Photo 20

Photo 21

Photo 22

Photo 24

Photo 25

Rear Driver Diff Mount Mod

Front Cross Member Installation

Differential Mount to Front Cross Member

Rear Cross Member Installation—Looking From Rear

Photo 23

Grind if
needed on
Driver and
Passenger

Front Cross Member Rear Bolt Installation