Rough Country 875.20 - Manual (Page 11)

48. Remove the brake line block as shown using a 10mm
socket and remove the brake line clip securing the brake
line to the frame mount. See Photo 44.
49. Using a cutting tool, cut the factory bracket as shown to
release the brake line. See Photo 45.
50. Install the supplied brake line bracket using the supplied
3/8” x 1” bolts, washers and nuts and install the brake line
in the new bracket as shown in Photo 46.
51. Swing the sway bar down and install the new sway bar link
on the lower control arm using a 17mm wrench. See
Photo 47.
52. Install ABS wire back into bearing using a 5mm allen
socket. Install brake rotor / brake caliper assembly using
stock hardware. Tighten using a 21mm wrench. See
Photo 48.
53. Install supplied cotter keys on the upper ball joint and tie rod ends. See Photo 49.
54. Install skid plate using supplied 3/8 x1” bolts on the front and rear cross member. Tighten with a 14mm socket. Rear
cross member shown in Photo 50.
55. Tighten lower control arm bolts using 22mm wrench.
Photo 50 Photo 49
Photo 48 Photo 47
Un Bolt Brake Line Block
Photo 44 Photo 45
Photo 46
Cut Factory Brake Line Bracket to Release Line
Install Bracket to Factory Mount and Brake Line
Install New Sway Bar to Lower Control Arm Re Install Brake Assembly
Install Cotter Pins to Upper Ball Joint and Tie
Rod Ends
Install Lower Skid Plate