Rough Country 875.20 - Manual (Page 6)

15. Mark the front drive shaft orientation, remove front drive
shaft, retaining factory hardware. (4WD ONLY)
16. Using a 15mm remove the front shafts from the
differential as shown in Photo 13. (4WD ONLY). Retain
stock hardware.
17. Support the differential with a floor jack or jack stand
and remove the 2 lower differential bolt on the driver and
passenger side using a 22mm socket and 19mm wrench.
Passenger side differential bolt shown in Photo 14.
Driver shown in Photo 15. Retain the stock hardware for
reuse.(4WD ONLY)
18. With the skid plate removed, remove the cross member
as shown in Photo 16 using a 14mm wrench /socket.
19. Remove rear differential bolt on the driver side using a
19mm wrench. See Photo 17. (4WD ONLY)
20. Remove the differential vent hose from the top of the differential and lower the differential from the vehicle. (4WD
ONLY)
21. Mark 2 1/2” from the center of the upper drivers old differential mounting hole as shown in Photo 18 and 4” from the
side of the frame through the center of the control arm hole as shown in Photo 19. (4WD ONLY)
Photo 13
Photo 14 Photo 15
Photo 17 Photo 16
Photo 18 Photo 19
Remove Front Drive Shafts
Remove Passenger Diff Bolt Remove Driver Side Diff Bolt
Remove Passen-
ger Diff Bolt
Remove Rear Cross Member Remove Rear Diff Bolt on Driver Side
Trim Driver Side Diff
Mount—Shown from Rear
Looking Forward
Trim Driver Side Diff
Mount—Shown from Rear
Looking Forward