Rough Country 75113-15 - Manual (Page 6)

PowerBoard ® – Installation Instructions
Rev. T 0713 75113 pg. 6
Puncture the grommet in the fl oor panel near the front door and thread the two
wires from the Wiring Harness through the fi rewall.
Wiring
Harness
Puncture Grommet
(Driver’s Side)
Thread Wires
through Grommet
Route the longer leg of the harness across the front of the engine compartment
and down to the motor on the passenger’s side step. Route the shorter leg to
the driver’s side. Use the 7" Cable Ties in the parts kit to secure the harness to
the cowling clips on the fi re wall in the engine compartment. Secure the harness
to the frame in the wheel wells.
Wiring
Harness
7" Cable
Ties
Secure Wiring Harness Install Wires – Driver’s Side
Drill a 9/32" hole in the fl oor panel and install the Rubber Grommet from the
parts kit. Then thread the wires from the harness through the Grommet.
Pull the wires up through the fl oor on both sides and seal all holes with Silicone
Sealant.
Drill Hole and install
Grommet
Wiring
Harness
Thread Wires through
Grommet
Install Wires – Passenger’s Side
Open the door. Use a fl at screwdriver to pop off the Step Plate in the door
opening. When the fasteners release, slide the Kick Panel out from under the
seat. Do this on both sides of the vehicle.
Peel back the carpet. Move the wiring harness out of the way.
Refer to the wiring instructions for installation steps specifi c to your vehicle.
Remove Step Plate
Remove Step Plate and Kick Plate