Powerboard, Wiring instructions, Driver side wiring passenger side wiring – Rough Country 75113-15 User Manual
Page 14
Rev. T 0713
75113 Wiring pg. 14
PowerBoard
®
– Wiring Instructions
1. Remove the front door step plate, lift carpet and pull PowerBoard
®
trigger wires
through fl oor of vehicle.
2. Locate the Rear Door Ajar Wire (dark blue with white stripe) on the black
connector below the hood-release lever. There will be two wires this color; use
the wire located on the row closest to the plug release.
3. Cut this wire and install a Single Diode Harness as shown in A.
4. Trim a trigger wire to the correct length and it to the blue connector of the Single
Diode Harness.
5. Locate the Front Door Ajar Wire (tan) on the large connector behind the
connector in Step 2.
6. Cut this wire and install a Single Diode Harness as shown in B.
7. Trim a trigger wire to the correct length and connect it to the blue connector of
the Single Diode Harness.
8. Wrap all connections with electrical tape and secure any loose wires.
GM Truck – Luxury and UP Level
(1999 – 2002)
Notes:
1. All signal wires tapped into will be 18Ga. Do not tap into anything with a thicker gauge than this.
2. Occasionally the wire colors do not match the wire schematics. Under these circumstances, you will need to locate the door ajar signal wires.
3. Make sure you secure all wires after installation. Loose wires can be damaged and may cause a failure of the PowerBoard's function.
Driver Side Wiring
Passenger Side Wiring
A
B
Single Diode
Harness
Qty - 4
Make sure Single Diode Harnesses
are oriented properly for the
PowerBoard
®
to function.
A
Diode
Trigger Wire
To Rear of Vehicle
To Front Door Panel
Trigger Wire
Diode
1. Remove the front door step plate, lift carpet and pull PowerBoard
®
trigger wires
through fl oor of vehicle.
2. Locate the two wire bundles running up along the kick panel area below the
glove compartment.
3. Unwrap the bundles and locate the Front and Rear Door Ajar wires (both dark
blue with white stripe), one in each bundle.
4. Cut each wire and install a Single Diode Harness as shown in C. Make sure that
the leg with the diode is toward the top.
5. Trim each trigger wire to the correct length and connect to the blue connector of
the Single Diode Harness.
6. Wrap all connections with electrical tape and secure any loose wires.
B
C
Diode
Diode
Butt
Connector
Qty - 8
PowerBoard
®
Trigger Wire
PowerBoard
®
Trigger Wire