beautypg.com

Powerboard, Wiring instructions, Driver side wiring passenger side wiring – Rough Country 75113-15 User Manual

Page 13

background image

Rev. T 0713

75113 Wiring pg. 13

PowerBoard

®

– Wiring Instructions

1. Remove the front door step plate, lift carpet and pull PowerBoard

®

trigger wires

through fl oor of vehicle.

2. Open wire bundle under front door step plate and locate 18Ga Rear Door Ajar

Wire (light blue with black stripe).

3. Use a Posi-Tap connector to splice the shorter trigger wire into the Rear Door

Ajar wire (light blue with black stripe).

4. Remove the door panel to access the wire bundle at the black cam-plug from the

window control panel. Open the bundle and locate 18Ga Door Ajar Wire (grey
with black stripe).

5. Route the longer trigger wire through the front door accordion to the door panel.

6. Use a Posi-Tap connector to splice the longer trigger wire into the Door Ajar wire

(grey with black stripe).

GM Truck (2003 – 2007)

Notes:

1. All signal wires tapped into will be 18Ga. Do not tap into anything with a thicker gauge than this.

2. Occasionally the wire colors do not match the wire schematics. Under these circumstances, you will need to locate the door ajar signal wires.

3. Make sure you secure all wires after installation. Loose wires can be damaged and may cause a failure of the PowerBoard's function.

B

A

Driver Side Wiring

Passenger Side Wiring

Front Door
Panel

Front Sill
Plate

Grey-Black

Front

Rear

D

C

Front Sill Plate

Posi-Tap™
Connector

1. Remove the front door step plate, lift carpet and pull PowerBoard

®

trigger wires

through fl oor of vehicle.

2. Open wire bundle under front door step plate and locate 18Ga Rear Door Ajar

Wire (green with black stripe).

3. Use a Posi-Tap connector to splice the shorter trigger wire into the Rear Door

Ajar wire (green with black stripe).

4. Remove the door panel to access the wire bundle at the black cam-plug from the

window control panel. Open the bundle and locate 18Ga Door Ajar Wire (black
with white stripe).

5. Route the longer trigger wire through the front door accordion to the door panel.

6. Use a Posi-Tap connector to splice the longer trigger wire into the Door Ajar wire

(black with white stripe).

Grey-Black

B

A

Lt. Blue-Black

Lt. Blue-Black

Front Door Panel

D

C

Green-Black

Green-Black

Black-White

Black-White