Rough Country 75113-15 - Manual (Page 5)

PowerBoard ® – Installation Instructions
Rev. T 0713 75113 pg. 5
Tighten the Upper 8mm Nut.
Adjust the bottom edge to make
sure that it is horizontal. Then
tighten the Small Washer Head
Bolt.
Finger tighten the Button Head
Bolts at this time.
8mm
Nut
Button
Head Bolts
Small Washer
Head Hex Bolt
Make sure
edge is
horizontal
Adjust and Tighten Fasteners
Use the 11" Cable Ties to secure the Controller to the factory wire conduit
above the brake booster on the driver’s side of the engine compartment.
Plug the Wiring Harness into the Controller. Make sure that the Locking Tabs
engage.
Controller
Wiring
Harness
Install Controller
11" Cable
Ties
Remove the fuse from the Wiring Harness.
Remove the fuse from the Wiring Harness. Failure to do so could result
in severe electrical shock which could harm the installer and/or damage
the vehicle.
Remove Fuse from Wiring Harness
Attach the red Power Lead wire to the positive lead in the junction box.
Attach the Ground Lead to the junction box mounting bracket.
Do not ground the wrench when engaged with the
Nut
Wiring Harness
Secure Leads