Printronix PrintCart - Manual (Page 39)

39
Battery Subpallet (BSP) Removal
1. If the PrintCart is plugged into an AC outlet, disconnect the plug from the
outlet.
2. Open the rear access door.
3. Shut off the inverter/charger main switch located on the front of the
inverter.
4. Open the front door and disconnect the main battery quick disconnect
and hang it so it is out of the way.
5. Disconnect the display power cord quick disconnect and move it to the
side.
6. Remove the two side restraining bolts that hold the BSP in place. These
are located on the side of the PrintCart frame.
7. Obtain a pallet jack and center one leg of the jack approximately
18 inches under the BSP.
8. If using a pallet jack, lift the BSP about 1/4 inch and slowly pull back on
the jack to remove the pallet from the PrintCart frame. If the BSP gets
caught with the PrintCart, the lift may be either too little or too much.
WARNING The BSP weighs between 150 and 230 lbs (depending on batteries
used). Be careful when removing the battery subpallet.
Figure 20. Battery Subpallet
Battery Subpallet
Pallet Jack