Atdec Levitate L-PW Installation manual - Manual (Page 6)

No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty
Ltd.
How to remove the Monitor
How to remove Cable Covers
1. If you inserted the Security Screw in Step 5, remove it
using a Phillips head screwdriver.
REMOVE
(anti-clockwise)
LIFT
Mounting Head
Quick Release
Coupling
1. Using a paper clip or a ball point pen press in the
three tabs holding the Cable Cover in place.
2. Pull the Cable Cover away from the Arm. Repeat this
process for each Cable Cover.
REMOVE
TIP: Access the tabs through the three
pinholes nearest the Cable Cover you
want to remove (e.g. A,B,C).
2. If you tightened the swivel tension in Step 5, loosen the
screw (do not remove) using the 2mm Allen Key supplied.
3. Unlock the Quick Release coupling (as shown below), and lift
the Monitor away from the Arm Assembly.
LESS TENSION
(anti-clockwise)
2mm Allen
Key
NOTE: When you press in the black inner button, the white outer
button will pop out to indicate the lock has been disengaged.
A
B
C
Press in BLACK
inner button
TO UNLOCK