Atdec Telehook TH-3060-LPT Installation manual - Manual

Wall Plate
Coach Screw
6mm (¼") hole Timber Stud
Nylon Anchor (x4)
M5/6/8 Washer
(x4 each)
M5x30/16mm (x4 each)
M6x30/16mm (x4 each)
M8x30/16mm (x4 each)
Display Mounting
Screws
M4/5 Spacer (x4)
M6/8 Spacer (x4)
Note: Use a stud finder to accurately locate the center of
the stud. Ensure that all two screws fix securely into the stud.
Hardware
Coach Screw (x4)
Installation Instructions
TH-3060-LPT
Components Checklist
Flat Screen Wall Mount | Tilt
Wall Plate
Tilt Bracket (x2)
IMPORTANT INFORMATION
! IMPORTANT - Install Telehook 3060 Wall Mount as per Installation Instructions.
! This product supports a load from 8kg (17.6lbs) min. to 50kg (110lbs) max.
! This product only supports displays with mounting hole configurations from 200mm x 100mm min.
to 800mm x 500mm max.
! The manufacturer does not accept responsibility for incorrect installation.
! Before installing this Telehook product, please check the display ventilation requirements with your
LED/LCD manufacturer.
Step 1. Check Components
Step 2. Mounting the Wall Plate
Tools Required:
‡ Power Drill
‡ 6mm (¼") drill bit
‡ 3KLOOLSV +HDG VFUHZGULYHU
‡ 10mm ( 3 /
8
") masonry drill bit
‡ /DUJH )ODW +HDG VFUHZGULYHU
‡ 13mm (½") Socket Wrench or Shifter
Tip: Use a spirit level to ensure wall plate is horizontal.
Masonry Wall Timber Stud
OR
Check you have received all parts against the Component CheckliVW DQG +DUGZDUH DERYH
Tension Tool
Wall Plate
Coach Screw
Nylon Anchor
10mm ( 3 /
8
") hole
‡ PP 3 /
8
") drill bit
‡ Spirit Level
Self-adhesive
Foam Pad