Atdec Telehook TH-3070-CT-B2B Installation manual - Manual

Installation Instructions TH-3070-CT-B2B
Component Checklist
Back to Back Accessory for TH-3070-CTL & TH3070-CTS
Horizontal Rail
M6/M8
Spacer (x4 each)
2mm/2.5mm/5mm
8mm Allen Key
HARDWARE
Display Mounting
Screws (x4 each)
M6x16mm/30mm/45mm
M8x16mm/30mm/50mm
Tools Required:
• 17mm(0.7”) Socket Wrench or Shifter
Mounting
Bracket (x2)
! IMPORTANT - Install Telehook 3070 Back to Back Accessory as per installation instruction.
! This product is to be installed in conjunction with TH-3070-CTL and TH-3070-CTS mounts only.
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received against the component checklist and hardware above.
Bracket Locking
Plate (x2)
M8x15mm
Screw (x2)
Cable
Clip (x2)
M4x12mm
Screw (x2)
Clamp Cover
Bottom
Clamp Cover
Middle
Clamp Cover
Side (x2)
M6/M8 Washer
(x4 each)
M10x30
Screw
M10
Washer
B2B Head
Clamp Assembly
Step 2. Remove the clamp parts from Head Assembly of TH-3070-CTL/CTS
Step 3. Assemble the clamp parts to B2B Head Assembly
3
5
4
6
6
A. Insert the four washers (item 6) to the four holes.
B. Put the clamp (item 5) in place.
C. Put the spacer (item 4) in place.
D. Attach the bolts (item 2) and nuts (item 1) with washers (item 3).
E. Tighten using the supplied 8mm Allen Key paired with the required 17mm
Socket Wrench or Shifter.
1
2
3
3
5
4
6
6
A. Use the required 17mm Socket Wrench or Shifter to hold the nuts (item 1).
B. Use the supplied 8mm Allen Key to loosen the bolts (item 2).
C. Remove all the clamp parts items 1 to 6.
1
2
1
2
3
1
2