Atdec Levitate L-PW Installation manual - Manual (Page 2)

Insert
Brake Pin
PUSH
B - BOLT THROUGH
B1. Remove the Desk Clamp using the 5mm Allen Key supplied.
B3. Install the Base Plate to replace the Desk Clamp
(no screw required).
TIP: To correctly insert the Brake Pin, so that the head of the Brake
Pin is flush, the base and Lower Arm must be aligned as shown
above.
Desk Clamp
5mm
Allen Key
Base Plate
B4. Drill an 8mm ( 5 /
16
”) hole through the work surface where you
want the centre of the base to be.
NOTE: The hole should be at least 55mm (2.17”) from any work
surface edge to allow for the diameter of the base.
B5. Select the appropriate length bolt, 45mm or 60mm
depending on the work surface thickness.
SHORT (45mm) suits work
surface thickness between
14-28mm (0.5”-1.1”) .
LONG (60mm) suits work
surface thickness between
29-43mm (1.1”-1.7”) .
Max.
28mm (1.1”)
Min.
14mm (0.5”)
Max.
25mm (1”)
Min.
17mm (0.7”)
Max.
25mm (1”)
Min.
17mm (0.7”)
Max.
43mm (1.7”)
Min.
29mm (1.1”)
Use 1,2, or 3 Bolt Through Washers to provide a thread length of
17mm minimum to 25mm maximum (0.7”-1”) protruding above
the work surface.
TIP: For work surfaces thicker than 43mm
(1.7”) , longer M8 bolts
can be purchased from hardware stores.
B6. Align the centre of the base over the pre-drilled hole.
Using the hardware selected in B5 fasten the base to the work
surface.
Step 3. Tighten Tension Bolts
1. Lift and support the weight of the Upper
and Lower Arms.
PUSH
2. Using the 5mm Allen Key supplied, tighten
the Upper and Lower Arm Tension Bolts until
the Arm Assembly supports its own weight.
REMOVE
(anti-clockwise)
45mm or
60mm Bolt
Bolt Through
Washer
5mm Allen Key
TIGHTEN
FIRMLY
(clockwise)
MORE TENSION
(clockwise)
LESS TENSION
(anti-clockwise)
The default base setup allows 360° of rotation of the Lower Arm
around the base. If you want to limit the Lower Arm rotation to
180° go to B2, if not skip to B3.
B2. OPTIONAL 180° ROTATION
To limit the Lower Arm rotation to 180° insert the Brake Pin (as
shown below). Then go to B3.
Lower Arm
Tension Bolt
Upper Arm
Tension Bolt
OR