Atdec Telehook TH-3060-LPF Installation manual - Manual

Nylon Anchor (x2)
Dry Wall anchor (x4)
M5/6/8 Washer
(x4 each)
M5x30/16mm (x4 each)
M6x30/16mm (x4 each)
M8x30/16mm (x4 each)
Display Mounting
Screws
M4/5 Spacer (x4)
M6/8 Spacer (x4)
Wall Plate
10mm( 3
8
") Hole
Dry Wall Anchor
Dry Wall Anchor Screw
Note: Each Dry Wall anchor should be at a
maximum distance from the next anchor point.
This is the recommended mounting pattern for
Dry Wall Anchors.
Coach Screw
Wall Plate
10mm( 3
8
") Hole
Nylon Anchor
6mm(
1
4
") Hole Timber Stud
Wall Plate
Coach Screw
Note: Use a stud finder to accurately locate
the centre of the stud. Ensure that all two
screws fix securely into the stud.
Hardware
Coach Screw (x2)
Installation Instructions
TH-3060-LPF
Components Checklist
Flat Screen Wall Mount | Fixed
Wall Plate Display Bracket (x2)
IMPORTANT INFORMATION
! IMPORTANT - Install Telehook 3060 Wall Mount as per Installation Instructions.
! This product supports a maximum load of 65kg (143.3lbs).
! This product supports displays with mounting hole configurations from 100mm (4”) to 500mm (19½”) high,
and from 200mm (8”) to 810mm (32”) wide.
! The manufacturer does not accept responsibility for incorrect installation.
! Before installing this Telehook product, please check the display ventilation requirements with your
LED/LCD manufacturer.
Step 1. Check Components
Step 2. Mounting the Wall Plate
10mm ( drill bit
3
8
") ‡
Spirit Level ‡
Tools Required:
Power Drill ‡
6mm (
1
4
") drill bit ‡
Phillips Head screwdriver ‡
10mm ( 3
8
") masonry drill bit ‡
Large Flat Head Screw Driver ‡
13mm ( 1
2
") Socket Wrench or Shifter ‡
Dry Wall
Tip: Use a spirit level to ensure wall plate is horizontal.
Masonry Wall Timber Stud
OR OR
Check you have received all parts against the component checklist and Hardware above.