Atdec Levitate L-PW Installation manual - Manual (Page 3)

Mounting Head
Quick Release
Coupling
Press in WHITE
outer button
TO LOCK
Recessed Mounting Holes or
Display with a Curved R ear P ane l
If the Mounting Holes are recessed into the
back of the monitor, or the monitor has
a curved rear panel, use the Spacer Bushes
supplied to pack the Mounting Holes.
Spacer Bush (x4)
Display Mounting
Screws (x4)
Mounting Hole
Step 4. Attach Mounting Head to Monitor
Step 5. Attach Monitor onto Arm Assembly (How do I remove the Monitor? See final page for help)
1. Select appropriate Display Mounting Screws from hardware ‘BAG B’ to suit the
monitor, and fasten the Mounting Head to the back of the monitor.
Mounting Head
Display Mounting
Screws (x4)
Mounting Hole
TOP OF
MONITOR
2. Push the Cover Plate over the
Mounting Head.
Press firmly around the inside edge
until you hear a ‘CLICK’.
Cover Plate
PUSH PUSH
1. Align and locate the Mounting Head onto the Quick Release
coupling.
2. Once the Mounting Head is in position, press in the WHITE
outer button to lock in place. Listen for ‘CLICK’.
NOTE: To unlock and remove the monitor, refer to instructions
on the final page.
3. If necessary adjust the swivel tension to increase head
stability. Use the 2mm Allen Key supplied.
2mm Allen
Key
MORE TENSION
(clockwise)
LESS TENSION
(anti-clockwise)
4. Choose SECURITY SCREW OR HEAD CAP option.
PUSH
Head Cap
DO NOT
OVERTIGHTEN
Security
Security
MORE TENSION
(clockwise)
SECURITY SCREW
HEAD CAP
TIP: When inserting the Security Washer ensure that the
thicker side is towards the monitor, so that it follows the
contour of the Mounting Head.
TIP: When inserting the Head Cap ensure that the thicker
side is towards the monitor, so that it follows the contour of
the Mounting Head.
Back of Monitor
Back of Monitor
PUSH