Atdec Visidec VF-WD Installation manual - Manual

Component Checklist
Component Checklist Component Checklist
Component Checklist Disassemble
Step 1
Using the supplied
Allen Key, remove
the bottom screw.
Installation Instructions
IMPORTANT: Ensure you have received all parts
against the component checklist prior to installing. Bits Bag
5mm Allen Key
Wall Plug (x2)
50mm Screw (x2)
Mounting Fasteners
M4x10mm Screw (x4)
M4x12mm Screw (x4)
M4x16mm Screw (x4)
Visidec Focus Wall Direct
supports a maximum
weight of 8kgs (17.5lbs)
TOOLS REQUIRED:
Power Drill
5.5mm (1/4”) Drill Bit
8mm (5/16”) Drill Bit
Phillips Head Screwdriver
NOTE: This product is
designed to support
a flat panel monitor
in a noninteractive
environment.
i.e. It should not be
used in a situation
where the display’s
position will be
frequently changed.
A
OR
Wall Plug
8mm (5/16”) hole
50mm Screw
Tip: Use a Spirit Level
to ensure this surface
is horizontal.
5.5mm (1/4”) hole
Timber
Stud
50mm Screw
Tip: Use a Spirit Level
to ensure this surface
is horizontal.
Step 2
Separate the two
components.
Wall Direct Assembly
Attach Base to Wall
Masonry Wall
B
Timber Stud Wall
VF-WD
NOTE: When attaching the
base to the wall, ensure
that the mounting holes
are vertically aligned.