Atdec Visidec VFS-Q Installation manual - Manual

Component Checklist
VFS-Q
IMPORTANT INFORMATION:
Step 1. Check Components
Step 2. Attach Upright Pole to Base
! IMPORTANT - Install Visidec Freestanding/Quad as per Installation Instructions.
! Each Quickshift Donut supports a maximum weight of 12kg (26.5lbs).
! This product supports VESA mounting hole configurations: 75x75mm and 100x100mm.
Display Mounting
Screws
Hardware
Check you have received all parts against the component checklist and Hardware above.
M4x12mm (x16)
VESA Plate (x4)
M4x10mm (x16)
M4x16mm (x16)
(Optional)
Security Screw (x4) Cable Ball
(x8)
Cable Clip (x4) 5/3mm Allen
Key (x1 each)
Installation Instructions
Freestanding
l
Quad
Base
Upright Pole
TOOLS REQUIRED:
Phillips Head Screw Driver
M8x50mm
Screw (x1)
Step 3. Attach Horizontal Support
Cable Slot
USER
BACK
TIGHTEN
FIRMLY
Upright Pole
M8x50mm Screw
5mm Allen Key
Attach the Upright Pole to the Base as shown
below. Ensure the Cable Slot faces towards the rear.
! The manufacturer accepts no responsibility for incorrect installation.
Horizontal
Support (x2)
Clamp the Horizontal Support around the Upright Pole at the required height. Ensure the
Slots in all the Poles are facing to the rear. Tighten support using the M6x25mm Cap
Screw and 5mm Allen Key supplied.
M6x25mm
Cap Screw (x2)
Cable slot to
face back
CLAMP
HOLD SUPPORT IN PLACE
TIGHTEN
M6x25mm Cap Screw
5mm Allen Key