VEGA VEGASCAN 850 - Manual (Page 65)

VEGASCAN 850 65
You get an overview of the sensors con-
nected to the VBUS1 terminal position and
their configuration status.
If a sensor was logged in as described in the
following menu "
Measurement loop/New“, the
status " Configure“ is written in the sensor
overview.
Setup - Adjustment with the PC
Create new measurement loop
• Choose the menu " C
onfiguration/Measure-
ment loop/New“.
• In the menu window "
Create new measure-
ment loop“, you choose "a new applica-
tion“ with "OK“.
You are in the menu window " Create new
measurement loop - Application“.
• Choose the parameter "
Level measure-
ment“ and the sensor type "Ultrasonic“.
• Click to "
Continue“.
• Choose in the next menu window "
Stand-
ard level measurement“ and "no options“.
• Click to "
Continue“.
After a few seconds, the menu window " Cre-
ate new measurement loop - Sensor configu-
ration“ opens.
• Click to "
Sensor coordination“.
The small menu window " Sensor coordina-
tion“ opens.