Veris Industries AE011 Install - Manual (Page 3)

Z206026-0A PAGE 3 ©2011 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 05113
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
TM
AE010/AE011 INSTALLATION GUIDE
If necessary, the E5x can be removed from the DIN rail using a flat screwdriver to pry
out the bottom (black) clip while lifting out the bottom of the meter.
4. Assemble enclosure cover
Locate screw holes in each corner of the AE010 cover.
Insert cover retention screws.
Affix cover onto enclosure by tightening all four screws.
5. Insert spacers
Plastic spacers are provided with the AE010. These fit into the enclosure on either side
of the meter, to prevent finger access and help keep out dust. Snap the spacer block
into pieces along the scored lines. The block contains six spacers, but only two are
needed.
Insert one spacer on either side of the E5x meter. Press the spacer until there is an
audible click.