Installation guide, Installation – Veris Industries AE011 Install User Manual

Page 2

Z206026-0A

PAGE 2

05113

Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.

AE010/AE011

INSTALLATION GUIDE

INSTALLATION

The AE010 components:

1. Install DIN Rail Clips to the back of the E5x

The E5x is shipped with a set of three DIN rail clips included. Insert these clips into the
slots on the back of the housing from the middle, moving outward. Stopping pegs
must face the underside of the housing. Push clips into place until there is an audible
click.

DIN Rail clip

(included with E5x meter)

When attaching the clips to the underside

of the E5x meter, these stopping pegs must

face inward towards the meter housing. Set

pegs into the available slots on the meter,

with the beveled side of the clip facing

toward the center of the meter.

When all clips are in place, the white clips must be flush with the top edge of the
housing, and the black clip must protrude slightly past the bottom edge.

2. Mount the AE010 enclosure to a wall or panel

Take care to protect the equipment from drill chips, filings, and other
contaminants when making the wire entry holes and mounting the
enclosure to prevent component damage or a future malfunction.

Cut holes cut in the enclosure for wire conduit connections prior to the
installation of the meter in the enclosure. Seal all holes properly to
maintain the enclosure rating.

The AE010 enclosure base can be installed using either a 2-point or a 4-point screw
mounting.

Punchout the corner holes for 4-point mounting:

Drill out the center holes for 2-point mounting:

3. Install E5x Onto DIN Rail Inside the AE010

Push the top of the E5x onto the DIN rail.

Then push the bottom of the meter onto the DIN rail until there is an audible click.

Mounting screw caps can be
used to cover screw heads.

1. Enclosure base
2. Enclosure cover with hinged, clear shield
3. Optional keys, locking mechanism, and pin
(sold separately as the Veris AE011)
4. Mounting screw caps
5. Spacer block
6. Cover retention screws