Veris Industries LDRA6 USER GUIDE - Manual (Page 18)

Chapter 4: Product Overview User Guide: LDRA6
www.rletech.com 970 484-6510 12
CHAPTER 4: START-UP
4-1 BOOT-UP
Make sure the RS-232 port is connected to a PC or terminal with a straight through cable. When the
LDRA6 is powered up, the boot ROM and flash program code are verified. Output similar to the screen
displayed below should appear on the terminal or terminal emulation software.
4-2 DISPLAYING THE HELP MENU
Once the system reaches this point, type? and press Enter to display the Help Menu. The Help Menu lists
the function commands for the LDRA6.
Help Menu – LDZ6/RASP6 V2.1
c - view/change CC settings
ld - view/change leak delay
sens – view/change leak zone sensitivity
e - view eeprom data
er - erase eeprom data – restores factory defaults
mbb - change modbus baud rate
mbp - change modbus parity
mr - reset modbus port/statistics
m - view modbus port settings/statistics
t - toggle modbus trace on/off
z - display leak zone readings
sr - summary relay mode
zr - zone relay mode
x - exit to bootloader
LDZ/Rasp6 Bootloader – LDZ6BOOT V2.1
Firmware Prgm Id: LDZ6/RASP6 V2.1
checksum valid
LDZ/Rasp6 bootup
LDZ6/RASP6 V2.1
Reading EEprom.......................................
..... ok
Modbus Addr:0 9600,8,N,1