Veris Technologies OpticMapper - Operating Instructions - Manual (Page 18)

Pub.# OM17-OpticMapper
4-4
If no data was logged during Data Acquisition, the following screen will be displayed:
Figure 10
Sensor DataLogger OM System Check
Here are the display readings shown when operating the Sensor DataLogger while running OM
system check:
After pressing #2 on figure 5 this screen appears:
Figure 11
Press #1 to continue with OM System check:
Figure 12
Figure 13
If the window is clean and in good condition (see 4-8), attach the dark side of the Reference to the
sensor. (Figure 14) Press any key to continue:
Figure 14