TROY Group MICR_IRD 3015 Security Printing Solutions User’s Guide - Manual (Page 94)

Section 5 Using the TROY Port Monitor
Security Printing Solutions User’s Guide -- 50- 70540-001 Rev. A
5-8
Security Tab
(cont.)
Alternate Escape Sequence – (used only for legacy application compatibility) enter the alternate ASCII character
number (0-255) to use as a replacement for the ASCII character 27 (escape character) in the PCL 5 data stream
sent to the printer. Press the Alt key and enter the ASCII character number.
Enable MICR Mode – check this box to enable
MICR mode when printing MICR documents.
HP Job Password – (used only for legacy
TROY printers) enter the password (0-65535)
that matches the job password (PJL command)
set in the TROY printer by the administrator.
Automatic Page Rotation – when printing
checks with the MICR line at the bottom of the
check paper, check this box to rotate the page
image 180 degrees to print the MICR line at the
top of the page, ensuring accurate MICR line
placement.
TROYmark ™ – select Disable for no
background image on the check or select either
Light, Medium, or Dark to use a pre-defined
density level for the background image, or
select Custom to use a custom density level that
best suits the design of your check.
Inclusion and Exclusion Regions – enter the
appropriate “X” (horizontal) and “Y” (vertical)
offset numerical values to define the top-left
starting point of the inclusion region and the
exclusion region(s), and then enter the width and
height numerical values to define the bottom-right
ending point of the inclusion and the exclusion
region(s) for placement of the TROYmark
™
background image and exclusion areas. Click on
Test to print a sample page to verify the inclusion/exclusion region placement on the check. Make adjustments to the
numerical values as needed. Each increment in the numeric value equals 1/600th of an inch.
TROYmark Background Image
(Inclusion rectangle)
Y value
Width Value
Check Document
Height Value
X value
exclusion
rectangle
Y value
X value