TROY Group MICR_IRD 3015 Security Printing Solutions User’s Guide - Manual (Page 100)

Section 6 Using the Printer Control Panel
Security Printing Solutions User’s Guide -- 50- 70540-001 Rev. A
6-6
Using the
Exact
Positioning
Technology If the MICR line on your checks does not meet the ANSI X/9B specification for MICR line placement, use this
feature to make small vertical, horizontal, or rotational positioning adjustments to the MICR line and/or page
image. Use the TROY MICR Document Template (54-17373-001) to verify the correct placement of the MICR
line on your checks after performing an adjustment (refer to Section 3 – MICR Quality Control in the TROY
MICR Basics Handbook for instructions on using the TROY MICR Document Template). If adjustments are
made simultaneously to the MICR line and the page image positions using positive numbers, then the sum of the
two numbers will be used as the offset value for the MICR line.
NOTE: The MICR line adjustments are preset at the factory. TROY recommends that you do not alter these
settings unless your bank of deposit notifies you of MICR line positioning errors on your deposited checks.
T
O EVALUATE THE PLACEMENT OF THE MICR LINE ON YOUR PRINTED CHECKS :
1. Print one page of test checks to use for evaluating the positioning of the E-13B MICR printing at the bottom
of each check (see the example below).
E-13B MICR Printing
MEMO
705
$
16-77/1220
20
ABC Company
1200 Main Street
Anytown, USA. 90023
PAY TO THE
ORDER OF