TROY Group Hewlett-Packard LaserJet 9000 Font DIMM Kit Installation Guide - Manual (Page 3)

DIMM Installation Guide
CAUTION: The DIMM is a static-sensitive device and can be permanently damaged if handled improperly.
Avoid touching any components or the metal contacts along the edge of the DIMM. Before
removing the DIMM from the anti-static bag, ground yourself by touching the metal portion of
the printer chassis to dissipate any static charge.
4. Push the DIMM slot retaining
clips out to the side (Figure 5),
and remove the existing DIMM to
allow installation of the new
image DIMM. Ensure the DIMM
is positioned correctly (Figure 5),
and then fully insert the DIMM
into the DIMM slot until it snaps
into place (the white retaining
clips should close automatically).
5. Replace the printer panels, and
reconnect the printer power cord
and data cable.
6. Refer to the TROY Quick-Start
Guide (provided with your TROY
DIMM Solution) for instructions
on installing the required TROY
software and support files.
Figure 5
NOTE: If assistance is required for removing or installing the DIMM, please call TROY Technical
Support at (800) 332-6427. Customers outside the United States, please call (304) 232-0899.
Document #50-70395-001 Rev. D
Page 3 of 22