Spicer Tandem Drive Axles Service Manual J340-S, J380-S, J400-S, W460-S - Manual (Page 36)

Castillated Pinion Nut All Fwd Carriers 1 3/4-12 600 Min.* 815 Min.*
Flanged Hex Nut, Rear All 1 3/4-12 900-1,200** 1,220-1,627**
Pinion Bearing Cage Bolts (Hex) All Fwd Carriers 9/16-12 5 115-135 155-183
Pinion Bearing Cage Bolts (Hex) All 5/8-11 5 160-180 218-245
Pinion Bearing Cage Bolts (Flanged) All 5/8-11 8 240-260 326-352
Differential Bearing Cap Bolts (Hex) All 3/4-10 5 275-320 373-433
Differential Bearing Cap Bolts (Flanged) All 3/4-10 8 295-340 400-460
Differential Case Nuts J 9/16-18 8 115-135 155-183
Differential Case Nuts W 5/8-18 8 160-180 218-245
Carrier Mounting Bolts (Hex) All 5/8-11 5 160-180 218-245
Carrier Mounting Bolts (Flanged) All 5/8-11 8 240-260 326-352
Differential Case Oil Scoop Bolts All 1/4-20 8 7-9 9-12
Oil Pipe Plugs All 3/4-14 8 35-45 47-61
Ring Gear Bolt Kit All M16 x 1.5-6G 300-320 406-434
Flanged Hex Nut, Input 1 3/4-12 900-1,200 1,220-1,267
Flanged Hex Nut, Output 1 1/2-18 500-600** 680-816**
Idler Shaft Nut 1 1/4-18 500-600 680-816
Inter-axle Differential Cover Bolt (Hex) 1/2-13 8 75-90 101-122
Intermediate Case Bolts (Flanged) 1/2-13 8 75-90 101-122
Output Shaft Retainer Bolts 3/8-16 8 30-40 41-55
Shift Fork Shaft 1/2-13 30-38 41-52
Air Shift Cylinder Bolts 3/8-16 8 30-40 41-55
AXLE / TORQUE SPECIFICATIONS
Position Thread
Power Divider Fasteners
Lb-Ft N-m
34
** Threads must be cleaned and dried, and coated with Loctite#518 adhesive compound, or its equivalent.
* If roll pin cannot be installed after minimum torque is attained, the nut must be advanced until roll pin can be installed.
** Threads must be cleaned and dried, and coated with Loctite#518 adhesive compound, or its equivalent.
Grade
Position Thread
Forward/Rear Axle Common Fasteners
Lb-Ft N-m Grade Model