Spicer Tandem Drive Axles Pro-40 Single Reduction and Single Reduction with Differential Lock - Manual (Page 24)

21 24
Forward Assembly
11. Remove the IAD assembly from the output side gear.
12. Remove the output side gear.
Note: Remove lube pump if you have one.
13. Inspect output side gear o-rings for nicks and cuts.
Replace if necessary.
14. Install new bearing cup.
15. Remove input shaft bearing cone and oil retainer, if
necessary.
16. Press new oil retainer on input shaft.
It is not recommended to reuse the oil retainer due to possi-
ble damage that may occur while removing the input shaft
bearing cone. While pressing on new oil retainer, make
sure not to over press, and/or press with the retainer at an
angle. If the retainer is bent or distorted it may rub on the
input cage or not seal properly to the v-ring.
17. Press input bearing cone on input shaft.
1—Press
2—Bearing
3—Oil retainer
4—Input shaft
1
2
3
4
1—Press
2—Plate
3—Drive sleeve 4—Input shaft bearing cone
5—Oil retainer
6—Input shaft
CAUTION
5
3
2
1
6
4
Fo
rward Assembly