Spicer Tandem Drive Axles Pro-40 Single Reduction and Single Reduction with Differential Lock User Manual

Page 21

Forward Assembly

Install Power Divider to Carrier Assembly - In Vehicle

Note: See page 20 for out of vehicle.

Note: Parts inspection and cleaning procedures are important

and should be adhered to. Cleanliness in your work area
is important as dirt is an abrasive and will cause prema-
ture wear of the otherwise serviceable parts.

During installation of power divider components, the inter-
axle differential, input shaft assembly or IAD shift system
parts may fall from the carrier if not careful. Use caution to
prevent injury or damage.

1. Make sure dowel pins are installed in carrier.

2. Install output side gear bearing cup, if removed.

Press bearing cup in carrier. Use a press and an
appropriate sleeve. Make certain bearing cup is
evenly and firmly seated. If a press is not available,
use a sleeve or a bearing driver tool and a hammer to
install the cup.

3. Lubricate o-rings.

4. Install the output side gear, if removed.

5. Install the IAD assembly to the output side gear. If

reusing the IAD assembly, install in the same direc-
tion as removed.

Note: For lube pump models, see page 23.

6. Out of the vehicle—on a bench, install lockout slid-

ing clutch onto the input shaft.

7. Install thrust washer.

1—Lubricate o-rings
2—Bearing cup

CAUTION