AASTRA Office 70IP-b User manual - Manual (Page 61)

Installation and First-Time Operation
61
Connecting the power supply
If your LAN supports Power-Over-Ethernet (PoE), the phone will be powered via the LAN cord and you will
not require a power adapter.
If your LAN does not support PoE or if you have installed a switch between the LAN and the phone that does
not support PoE, you will need the optional power adapter to power the phone.
Note: Only use the original power adapter
1. Plug the round connector of the thin power cord on the underside of the phone into the power socket.
2. Desktop installation only: To relieve the strain on the cable feed the cable through one of the cable
guides on the stand.
3. Connect the power supply to the mains.
Logging Your Phone on
Your system administrator has to prepare the system before you can log on your phone.
Labelling Configurable Keys
The Quick User’s Guide (enclosed supplement) contains labels for the configurable keys.
1. Cut out the label.
2. On the label make a note of the stored functions or of the names corresponding to the numbers stored.
3. Carefully remove the transparent cover next to the configurable keys.
4. Place the label into the recess next to the configurable keys.
5. Carefully replace the transparent cover.
The Quick User’s Guide is also available as an electronic document. You can download it from the internet.
Use the address indicated on the last page of this document.
In the electronic version of the Quick User’s Guide you can label the fields on the PC and then print them out.