AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 81)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 81 (104)
4) Press “OK”.
5) Enter a number of seconds the phone shall ring before it will answer the
call.
6) Press “OK”.
7) Enter a number of seconds a call shall be active.
8) Press “OK”. The test will be started automatically.
To stop the test switch the phone off and on again.
7.3.4 Syslog
The OpenMobility Manager and the RFPs’ are capable of propagating syslog
messages conforming to /8/. This feature together with the IP address of a
host collecting these messages can be configured.
Syslog has to be enabled by
• DHCP using the public options 227 and 228.
• Setting the syslog daemon server and port via the web interface.
To set up the syslog via DHCP or OM Configurator has the advantage, that
syslogs are available in earlier states of the RFP start-up.
The level of syslog messages in the default state allows the user, to have
control over the general system state and major failures.
7.3.5 ssh user shell
Each RFP offers a lot of command within the ssh shell. Most of them are
useful for diagnostic and may help experts, to resolve failures.
Note: Some commands can harm the system operation.
The ssh access of a RFP is open if