AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 59)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 59 (104)
The third step is to specify the WLAN parameters in a profile. Here you enter
the name (SSID) of the WLAN network and other parameters. The encryption
and authentication procedures are especially important and must be planned
carefully beforehand.
The access point can be assigned to a VLAN that conforms to 802.1q. All the
data that is received from and that is to be forwarded to the WLAN clients is
then carried by a VLAN. All the data that does not meet this condition, such
as VoIP packets, configuration data or authentication data (Radius), is given
the VLAN code of the RFP. The port of the network component to which the
access point is connected must be configured as a trunk port. The profile
parameters have preset values.
Parameter Range Notes
Beacon Period 50 – 65.535 Milliseconds The length of the intervals
between beacons.
DTIM Period 1 - 255 Beacons The number of beacons
between two DTIM (Delivery
Traffic Indication Map)
transmissions.