AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 80)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 80 (104)
Menu Phonebook
RFPI 10FFF21 02
FE PP: FP:
-dBm 50 57 50
RPN 02 01 00
PARK: 1F-10-FF-F0-21 RFP ID: 02*
RFP ID: 02*
*The ID of RFP to which the PP is currently associated to.
Frame error
Field strength
RFP ID
In this example the PP is currently connected to the RFP with the number 02.
The RFP 01 and 00 are also visible. The number “10FFF221 02” on the
upper right side refers to the PARK (Example 1F-10-F2-21) of the SIP-DECT
system and to the RFP to which the phone is currently connected to.
7.3.2 Aastra DECT 142 / Aastra 142d auto call test mode
You can set the Aastra DECT 142 / Aastra 142d to “auto call test mode” with
a few keystrokes. In this mode the phone will call a specified number
cyclically. You can use this feature to generate traffic for test purposes. This
mode is also active if the phone is on the charger.
1) Press the “Menu” soft key
2) Enter the following key sequence “R***76#”
3) Select “Auto Call Test”
4) Press “OK”.
5) Enter the phone number to call.
6) Press “OK”.
7) Enter a number of seconds between two calls.
8) Press “OK”.
9) Enter a number of seconds a call shall be active.
10) Press “OK”. The test will be started automatically.
To stop the test, switch the phone off and on again.
7.3.3 Aastra DECT 142 / Aastra 142d auto answer test mode
You can set the Aastra DECT 142 / Aastra 142d to “auto answer test mode”
with a few keystrokes. In this mode the phone will answer incoming calls
automatically. You can use this feature together this phones in the “auto call
test mode” for test purposes. This mode is also active if the phone is on the
charger.
1) Press the “Menu” soft key
2) Enter the following key sequence “R***76#”
3) Select “Auto Answer”