AASTRA SIP-DECT (Release 1.8)-Installation- and Administration Guide EN - Manual (Page 38)

Installation, Administration and Maintenance
Aastra depl-0900/0.4 Page: 38 (104)
Note: The PPs’ have to support DECT encryption which is not a mandatory
feature.
3.3.2.1.3 Regulatory domain
To define where the IP DECT is used the parameter regulatory domain has
to be configured. Existing installations are updated to the default value
“EMEA (ETSI)”.
To setup a North American FCC compliant installation the value has to be set
to “US (FCC/CI)”
In a North American US (FCC/CI) deployment, ETSI compliant RFPs’ are
made inactive and can not be activated if the regulatory domain is set to “US
(FCC/CI)”. Vice-versa is also true.
Only US (FCC/CI) DECT 142 handsets may be connected to RFPs’/OMM
designed for the US market and configured to use the US (FCC/CI)
regulatory domain.
3.3.2.2 SIP
The SIP settings cover all global settings matching the SIP signalling and the
RTP voice streams.
• Proxy Server
IP address or name of the SIP proxy server. If a hostname and
domain are used for the proxy server parameter, ensure that a
DNS server and domain are specified for your SIP-DECT
system via DHCP or the OM Configurator tool.
• Proxy Port
SIP proxy server’s port number. Default is 5060. To enable
DNS SRV support for proxy lookups, use a value of 0 for the
proxy port.
• Registrar Server
IP address or name of the SIP registrar. Enables the PPs’ to be
registered with a Registrar. If a hostname and domain are used
for the proxy server parameter, ensure that a DNS server and
domain are specified for your SIP-DECT system via DHCP or
the OM Configurator tool.
• Registrar Port
SIP Registrar’s port number. Default is 5060. To enable DNS
SRV support for registrar lookups, use a value of 0 for the
registrar port.
• Registration Period
The requested registration period, in seconds from the registrar.
Default is 3600.
• Outbound Proxy
Address of the outbound proxy server. All SIP messages
originating from the OMM are sent to this server. For example, if
you have a Session Border Controller in your network, then you
would normally set its address here. Optional.