Olympus IX71 - Manual (Page 68)

64
Fig. 102
@
²
³
|
Fig. 103
@
²
ƒ
…
Fig. 104
† ‡
9 Connecting the Cables (Figs. 102 to 104)
Cables and cords are vulnerable when bent or twisted. Never subject
them to excessive force.
Make sure that the main switch of the power supply is set to “ ”
(OFF) before connecting cables.
1. Connect the plug @ of the lamp housing or illumination column to
connector ² firmly.
2. Connect the hand switch plug or TH4 connection cable ³ to connector |.
With the IX71 frame, connect the other end of the TH4 connection cable
to the right side of the IX71 frame.
Always use the AC power adapter and power cord provided by
Olympus. If no power cord is provided, please select the proper power
cord by referring to the section “PROPER SELECTION OF THE POWER
SUPPLY CORD” at the end of this instruction manual.
3. Connect the power cord connector ƒ to connector … firmly.
4. Connect the power cord plug † to a wall outlet ‡.
Be sure to supply power from a grounded, 3-conductor power outlet
using the proper power cord. If the power outlet is not grounded
properly, Olympus can no longer warrant the electrical safety per-
formance of the equipment.
If the power cord or a connection cable comes in contact with the
lamp housing or surrounding equipment, the cord or cable may melt
and result in shock hazard. To prevent this, distribute the cords and
cables apart from the lamp housing.
ƒ …