Acura 2011 MDX - Manual (Page 161)

In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat's temperature
drops.
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
Follow these precautions when using
the seat heaters:
●
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current from the
battery.
● If the engine is left idling for an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.
A multi-information display message
may inform you when the battery
charge is getting low. See page
82 for
more information.
Seat Heaters and Seat Ventilation
If equipped
Both front seats are equipped with
seat heaters and an air ventilation
system. The passenger seat only has
heaters in the seat bottom because of
the side airbag system.
The ignition switch must be in the
ON (II) position to use the heaters
and the air ventilation system.
To use the heaters, press the
button. The indicator (red) next to
the button will come on. There are
four settings in the heaters:
HI
－ Three indicators on.
MID － Two indicators on.
LO － One indicator on.
OFF － All indicators off.
Passenger's
seat
HEATERS
Driver's
seat
VENTS
FRONT SEAT HEATER AND
SEAT VENTILATION
SWITCHES
INDICATOR
CONTINUED
Seat Heaters, Seat Heaters and Seat Ventilation
157
Instruments
and
Controls
10/06/29 11:59:04 11 ACURA MDX MMC North America Owner's M 50 31STX640 enu
2011 MDX