Acura 2013 MDX - Manual (Page 81)

If the indicator comes on at any other
time, there is a problem with the
CMBS. You will also see a
‘‘CHECK
CMBS SYSTEM ’’ message on the
multi-information display. If this
happens, take your vehicle to your
dealer, and have it checked. For
more information, see page
463 .
When this indicator is on, the CMBS
is not working.
Door/Tailgate Open
Indicator
This indicator comes on red if any
door or the tailgate is not closed
tightly.
You will also see a corresponding
indicator(s) on the multi-information
display to indicate which door and/
or the tailgate is not closed tightly
(see page
12 ).
Blind Spot Information
System (BSI) Indicator
On models with blind spot information
system (BSI)
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
The BSI indicator also comes on if
the rear bumper becomes dirty while
driving. You will see a
‘‘BLIND SPOT
NOT AVAILABLE ’’ message on the
multi-information display.
When you clean the rear bumper, the
indicator should go off after you
begin driving again.
When you turn the system on, the
indicator will turn off.
If the indicator comes on at any other
time, there is a problem with BSI.
You will also see a
‘‘CHECK BLIND
SPOT SYSTEM ’’ message on the
multi-information display. If this
happens, take your vehicle to a
dealer, and have it checked (For
more information, see page
482 ).
When this indicator is on, BSI is not
working.
Instrument Panel Indicators
76
12/07/17 18:10:57 13 ACURA MDX MMC North America Owner's M 50 31STX660 enu
2013 MDX
Instruments
and
Controls