Acura 2013 MDX - Manual (Page 131)

1. MIST
2. OFF
3. INT － Intermittent
4. LO － Low speed
5. HI － High speed
6. Windshield washers
Push the right lever up or down to
select a position.
MIST － The wipers run at high
speed until you release the lever.
OFF － The wipers are not activated.
INT － The length of the wipe
interval is varied automatically
according to vehicle speed.
Vary the delay by turning the
adjustment ring. If you turn it to the
shortest delay (
position), the
wipers change to low speed
operation when the vehicle speed
exceeds 12 mph (20 km/h).
To change the ‘‘WIPER ACTION’’
setting, see page 123 .
LO － The wipers run at low speed.
HI － The wipers run at high speed.
Windshield Washer － Pull the
wiper control lever toward you, and
hold it. The washers spray until you
release the lever. The wipers run at
low speed, then complete one more
sweep after you release the lever.
When you activate the windshield
washer with the headlights turned
on, the headlight washer will be
activated under certain conditions.
For more information, see following
Headlight Washers section.
Windshield Wipers and Washers
126
12/07/17 18:10:57 13 ACURA MDX MMC North America Owner's M 50 31STX660 enu
2013 MDX
Instruments
and
Controls