Acnodes FPC 7160 - Manual (Page 95)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
FPC 7160
15.6” Industrial Panel PC
CHAPTER 4 SYSTEM MAINTENANCE
4.1 SYSTEM MAINTENANCE INTRODUCTION
If the components of the FPC7160/ FPC7162 fail they must be replaced, such as the wireless LAN
module or the motherboard. Please contact the system reseller or vendor to purchase the replacement
parts. Back cover removal instructions and jumper settings for the FPC7160/ FPC7162 are described
below.
4.2 MOTHERBOARD REPLACEMENT
In the case of motherboard failure, please contact an IEI sales representative, reseller or system ven-
dor. The motherboard is accessible after opening the rear cover.
4.3 COVER REMOVAL
WARNING!
Turn off the power before removing the back cover. Risk of electrocution. Severe damage to the
product and injury to the body may occur if internal parts are touched while the power is still on.
WARNING!
Take antistatic precautions when working on the internal components. Some internal compo-
nents are easily damaged or destroyed by electrostatic discharge. Take antistatic precautions to
prevent electrostatic discharge.
To replace any of the following components,
Memory module
Wireless LAN module
The back cover of the FPC7160/ FPC7162 must be removed. To remove the back cover, unfasten the
retention screws and then lift the cover to remove.