Fpc 7160 – Acnodes FPC 7160 User Manual

Page 68

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 7160

15.6” Industrial Panel PC

Normal

DEFAULT

The normal parallel port mode is the standard mode

for parallel port operation.

EPP

The parallel port operates in the enhanced parallel port mode(EPP). The EPP mode
supports bi-directional communication between the system and the parallel port de-
vice and the transmission rates between the two are much faster than the Normal mode.

ECP+EPP

The parallel port operates in the extended capabilities port (ECP) mode. The ECP
mode supports bi-directional communication between the system and the parallel
port device and thetransmission rates between the two are much faster than the
Normal mode The parallel port is also be compatible with EPP devices described
above

Parallel Port IRQ [IRQ7]

Use the Parallel Port IRQ selection to set the parallel port interrupt address.

IRQ5

IRQ5 is assigned as the parallel port interrupt address

IRQ7 DEFAULT

IRQ7 is assigned as the parallel port interrupt address

Serial Port1 Address [3F8/IRQ4]

Use the Serial Port1 Address option to select the Serial Port 1 base address.

Disabled

No base address is assigned to Serial Port 1

3F8/IRQ4 DEFAULT

Serial Port 1 I/O port address is 3F8 and the interrupt address is IRQ4

3E8/IRQ4

Serial Port 1 I/O port address is 3E8 and the interrupt address is IRQ4

2E8/IRQ3

Serial Port 1 I/O port address is 2E8 and the interrupt address is IRQ3

Serial Port1 Mode [Normal]

Use the Serial Port1 Mode option to select the transmitting and receiving mode for the
first serial port.