Acnodes PC 6408 - Manual (Page 84)

14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
PC 6408
8” Fanless Panel PC
6.4 DIMM REPLACEMENT
Please read the warnings at the beginning of the previous section before attempting to access any
PC5153/ PC5173 internal components.
To install/replace the DIMM modules please follow the steps below.
Step 1: Remove the back cover (Section 4.4).
Step 2: Locate the DIMM socket on the motherboard near the right of the chassis. Push down on the
white levers of the socket until the DIMM module disengages from the socket (Figure 6-1).
Step 3: Push the new DIMM module until it engages and the white plastic end clips click into place.
Make sure the end clips are fully secured after installation.
6.5 ELEVATED PLATFORM REMOVAL
The elevated platform supports the optical drive and the hard drive. It is not necessary to remove the
optical drive bracket or hard drive bracket to remove the elevated platform.
Step 1: Unfasten the elevated platform screws on the top panel.
Step 2: Unfasten the elevated platform screws on the side panel.
Step 3: Unfasten the elevated platform screws on the bottom panel.
Step 4: Unfasten the internal elevated platform screws.
Step 5: Slide the elevated platform out of the chassis.