Pc 6408 – Acnodes PC 6408 User Manual

Page 47

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909.597.1939

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

PC 6408

8” Fanless Panel PC

Step 9: Secure the panel PC with the wall-mounting kit. To do this, stick the protective

cushion to the wall-mounting kit first. Then, put the wall-mounting kit on the top panel of

the panel PC. Carefully mark the location of the wall-mounting kit screw holes on the

wall. Drill a pilot hole at the marked location on the wall. Secure the wall-mounting kit to

the wall by inserting a retention screw into the pilot hole on the wall (Figure 4-30). This

step is to avoid the panel PC being pushed apart from the wall-mounting bracket acci-

dentally.

4.11.2 Panel/ Mounting

To mount the PC5153/ PC5173 flat panel PC into a panel, please follow the steps be-

low.

NOTE:

The maximum panel thickness should be no more than 6 mm.

Step 1: Select the position on the panel to mount the PC5153/ PC5173.

Step 2: Cut out a section of the panel that corresponds to the rear panel dimensions of

the PC5153/ PC5173. The recommended cutout sizes are shown below (Figure 4-31,

Figure 4-32 and Figure 4-33).