Accusys ExaRAID A16U-IS - Manual (Page 12)

Accusys A16R/A16U-IS
10
By GUI
1. Open a browser and enter the RAID system’s IP address in the address
field. (The default IP address is 192.168.0.1)
2. Log in from GUI to open the Config Mode. The default username and
password are “admin” and “0000”.
3. Click System Management > Restart/Halt to open the Restart/Halt
page.
4. Select Both Controllers from the Controller ID drop down menu and
select Halt from the Action drop down menu and click Apply.
5. Click Confirm to confirm and shut down the system.
6. Turn the power off when the LCD displays “Ready to power off!”.
Step 4. Setting the LAN Connection
LAN communication enables the Graphic User Interface (GUI) on your
PC to monitor and control the RAID system to easily monitor and
configure the RAID system.
A LAN/WAN connection is required. Follow the procedures below:
To set up the LAN connection:
1. Attach one end of the Ethernet cable to the LAN port on one of the
Controller board.
2. Attach the other end of the Ethernet cable to a LAN switch or directly
to a LAN port on the Host PC or Server using a crossover cable.
3. Set the RAID IP Address. See below for more details.