JVC DLA-X95R - Manual (Page 43)

Adjusting to the Preferred Gamma Setting (Custom Gamma)
Gamma setting can be adjusted according to your
preferred video quality.
* During 3D signal input and when “Picture Mode” is set
to “3D”, gamma setting cannot be adjusted.
1
Press the [MENU] button to display
the menu
2
Select “Picture Adjust”"“Advanced”
"
“Custom Gamma” from the menu
.
MENU BACK
0
0
0
0
>
MENU BACK
0
Back Operate
Select
Exit Back Operate
Select
Exit
Picture Adjust Picture Adjust
Lens Aperture
Color Management
User Name Edit
Off
Off Clear Motion Drive
Custom Gamma
NR
MPC Level
Advanced
Advanced
High
Reset
Tint
Color
Brightness
Contrast
Picture Tone
Dark/Bright Level
Film 1 Gamma
Xenon 1 Color Temp.
Film 1 Color Profile
Film Picture Mode
Lamp Power
3
Select the item to set (Custom 1 to
Custom 3), and press the [OK] button.
.
MENU BACK
1023
512
0 50 100(%)
>>
D
Gradation diagram
corresponding to the
gamma curve
Gamma Curve
Correction Value
Custom 3
Custom 2
Custom 1
Custom Gamma
Back Operate
Select
Exit
Picture Adjust
Reset
Blue
Green
Red
White
4
Select “Correction Value”, and press
the H I keys to select a value for
correction to be based on (initial
value)
0
For details on the correction value, please refer
to p. 41.
A
Normal, A, B, C, D, 1.8, 1.9, 2.0, 2.1, 2.2, 2.3, 2.4,
2.5, 2.6
B
Normal, A, B, C, D, E, F, G, H, 1.8, 1.9, 2.0, 2.1, 2.2,
2.3, 2.4, 2.5, 2.6
D
C
When “Picture Mode” is set to “Film”: “Film 1”, “Film
2”, “Film 3”, Film 4
When “Picture Mode” is set to a value other than
“Film”: Normal, A, B, C, D, E, F, G, H, 1.8, 1.9, 2.0,
2.1, 2.2, 2.3, 2.4, 2.5, 2.6
0
The smaller the value, the brighter the dark
areas of the image will become. At the same
time, the bright areas will appear blown out.
0
The factory settings for Custom 1 to Custom 3
are the same as that for the “Normal” setting.
5
Select the color to adjust, and press
the [OK] button
6
Press the H I keys to select the area
to adjust (from the 12 points on the
gamma curve), followed by using the
JK
keys to adjust the brightness
0
After adjustment is complete, press the [OK]
button to confirm the setting.
0
Selecting “Reset” restores the setting to the
initial value (Normal).
7 Press the [MENU] button to exit
43
Adjust/Set