FIAT Idea User Manual

Page 144

143

CAR

MAINTENANCE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

SAFETY DEVICES

CORRECT USE OF THE CAR

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

fig. 14

F0H0164m

fig. 15

F0H0165m

fig. 16

F0H0166m

REFITTING THE STANDARD
WHEEL

Following the procedure described previ-
ously, raise the car and remove the spare
wheel.

For versions with steel rim

Proceed as follows:
❒ Make sure the contact surfaces be-

tween standard wheel and hub are
clean so that the fastening bolts will
not come loose;

❒ Fit the standard wheel by inserting the

first bolt in the hole closest to the in-
flation valve;

❒ Fit the wheel cap making the groove

(on the wheel cap) coincide with the
inflation valve and fit the other three
bolts;

❒ Using the wrench provided, tighten

the fastening bolts;

❒ Lower the car and remove the jack;
❒ Using the wrench provided, fully

tighten the bolts in the sequence
shown previously for the spare
wheel;

IMPORTANT Incorrect fitting may cause
the wheel cap to come off when the car is
travelling.

133-160 idea GB 1 ed 10-07-2008 8:30 Pagina 143