FIAT 500L - Manual (Page 190)

JACK
Please note that:
❒ the jack weight is 1,76 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired and in the event of a
fault it must be replaced by another original one;
❒ no tool other than its cranking device may be
fitted on the jack.
To change a wheel, proceed as follows:
❒ Stop the car in a position that is not dangerous for
oncoming traffic where you can change the wheel
safely. The ground must be flat and sufficiently
compact;
❒ switch off the engine, pull up the handbrake and
engage the 1 st gear or reverse. Wear the reflective
safety jacket (compulsory by law) before getting
out of the car;
❒ open the luggage compartment, pull tab A fig. 145
and lift up the mat B;
❒ using the wrench A fig. 146 located in the tool
box, loosen the locking device, take the tool box B
and place it close to the wheel to be replaced.
Then take the space-saver wheel C;
fig. 145 F0Y0083
fig. 146 F0Y0096
186
GETTINGTO KNOW
YOURCAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX