Yamaha CP 33 - Manual (Page 8)

Before Using the CP33
CP33 Owner’s Manual 8
Introduction
Before Using the CP33
1
Make sure that the instrument’s [STANDBY/ON] switch on the rear panel is at the
STANDBY position.
2
Connect the supplied PA-3C power adaptor's DC cable to the DC IN jack (page 14) on
the instrument’s rear panel.
3
Connect the other end of the power cord to an AC outlet. Make sure your CP33 meets
the voltage requirement for the country or region in which it is being used.
Use ONLY a Yamaha PA-3C AC Power Adaptor (or other adaptor specifically recommended by Yamaha) to power your
instrument from the AC mains. The use of other adaptors may result in irreparable damage to both the adaptor and the
CP33.
Unplug the AC Power Adaptor when not using the CP33, or during electrical storms.
Power Supply Connections
DC-IN
FOOT PEDAL USB
SUSTAIN
STANDBY PHONES
MIDI
OUTPUT
OUT IN
L/MONO R
ON
AUX
FOOT PEDAL USB
SUSTAIN
STANDBY HONES
ON
AUX
WARNING
CAUTION