ZyXEL Communications ES-3124PWR - Manual (Page 217)

Dimension ES-3124PWR Ethernet Switch
Introducing the Commands 29-23
Table 29-5 Command Summary: Interface
COMMAND DESCRIPTION
multicast-limit Enables the interface multicast
limit.
multicast-limit Sets how many multicast packets
the interface receives per
second.
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
dlf-limit Sets the interface DLF limit in
packets per second (pps).
weight ... Sets the interface to use WFQ
weighting. A weight value of one
to eight is given to each variable
from wt 1 to wt 8.
egress set Sets the outgoing traffic port list
for a port-based VLAN.
pvid <1-4094> The default PVID is VLAN 1 for
all ports. Sets a PVID in the
range 1 to 4094 for the specified
interface.
ingress-check Enables the device to discard
incoming frames for VLANs that
are not included in a port
member set.
gvrp Enables this function to permit
VLAN groups beyond the local
switch.
frame-type Choose to accept both tagged
and untagged incoming frames
or just tagged incoming frames
on a port.
name Sets a name for your interface.
Enter a descriptive name (up to
nine printable ASCII characters).
vlan-trunking Enables VLAN Trunking on ports
connected to other switches or
routers (but not ports directly
connected to end users) to allow
frames belonging to unknown
VLAN groups to pass through the
switch.
flow-control Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
qos priority <0 .. 7> Sets the quality of service priority
for an interface.