ZyXEL Communications NBG-318S - Manual (Page 163)

Chapter 16 Remote Management
NBG-318S User’s Guide
163
Figure 85 Telnet Configuration on a TCP/IP Network
16.4 Telnet Screen
To change your NBG-318S’s Telnet settings, click Management > Remote MGMT >
Telnet. The following screen displays.
Figure 86 Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
Table 65 Management > Remote MGMT > Telnet
LABEL DESCRIPTION
Server Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server Access Select the interface(s) through which a computer may access the NBG-318S using
this service.
Secured Client
IP Address
A secured client is a “trusted” computer that is allowed to communicate with the
NBG-318S using this service.
Select All to allow any computer to access the NBG-318S using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the NBG-318S using this service.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.