beautypg.com

2 remote management and nat, 3 system timeout, 2 www screen – ZyXEL Communications NBG-318S User Manual

Page 162: 3 telnet, 2 remote management and nat 16.1.3 system timeout, 2 www screen 16.3 telnet, Figure 84 management > remote mgmt > www, Table 64 management > remote mgmt > www

background image

Chapter 16 Remote Management

NBG-318S User’s Guide

162

1 You have disabled that service in one of the remote management screens.
2 The IP address in the Secured Client IP Address field does not match the client IP

address. If it does not match, the NBG-318S will disconnect the session immediately.

3 There is already another remote management session with an equal or higher priority

running. You may only have one remote management session running at one time.

4 There is a firewall rule that blocks it.

16.1.2 Remote Management and NAT

When NAT is enabled:

• Use the NBG-318S’s WAN IP address when configuring from the WAN.
• Use the NBG-318S’s LAN IP address when configuring from the LAN.

16.1.3 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds).
The NBG-318S automatically logs you out if the management session remains idle for longer
than this timeout period. The management session does not time out when a statistics screen is
polling. You can change the timeout period in the System screen

16.2 WWW Screen

To change your NBG-318S’s World Wide Web settings, click Management > Remote
MGMT
to display the WWW screen.

Figure 84 Management > Remote MGMT > WWW

The following table describes the labels in this screen

Table 64 Management > Remote MGMT > WWW

16.3 Telnet

You can configure your NBG-318S for remote Telnet access as shown next. The administrator
uses Telnet from a computer on a remote network to access the NBG-318S.