ZyXEL Communications NBG-318S - Manual (Page 102)

Chapter 7 LAN
NBG-318S User’s Guide
102
7.3 LAN IP Screen
Use this screen to change your basic LAN settings. Click Network > LAN.
Figure 52 Network > LAN > IP
The following table describes the labels in this screen.
Table 37 Network > LAN > IP
LABEL DESCRIPTION
LAN TCP/IP
IP Address Type the IP address of your NBG-318S in dotted decimal notation 192.168.1.1
(factory default).
IP Subnet Mask The subnet mask specifies the network number portion of an IP address. Your
NBG-318S will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the NBG-318S.
Apply Click Apply to save your changes back to the NBG-318S.
Reset Click Reset to begin configuring this screen afresh.
7.4 LAN IP Alias
IP alias allows you to partition a physical network into different logical networks over the
same Ethernet interface. The NBG-318S supports three logical LAN interfaces via its single
physical Ethernet interface with the NBG-318S itself as the gateway for each LAN network.
To change your NBG-318S’s IP alias settings, click Network > LAN > IP Alias. The screen
appears as shown.