Problem solving, Problem solving –15 – Xerox DocuColor 2060 User Manual
Page 227

T
R A Y
4
A
C C E S S O R I E S
D O C U C O L O R
2 0 6 0 / 2 0 4 5
O P E R A T O R M A N U A L
AC
CESSO
RIES
5–15
Problem Solving
Tray 4 has an altitude sensor that detects the curl of the paper and adjusts the
Elevator Tray accordingly. If misfeeds and jams occur repeatedly:
•
Find the problem in the Problem column.
•
Follow the suggestion in the Suggested Solutions column until the
situation is corrected.
Problem
Suggested Solutions
Fault Code 052-310
Communication problem
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
Fault Code 052-320
Unexpected connection
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
Fault Code 052-210
No response from Tray 4
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
Fault Code 007-532
Tray 4 not ready to print
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on. If problem persists, use another
tray and call for service.
Fault Code 007-236
Tray 4 Tray Tilt Fault
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on. If problem persists, use another
tray and call for service.
Fault Code 007-239
Volt Failure
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on. If problem persists, use another
tray and call for service.
Fault Code 008-201
Drive motor problem
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on. If problem persists, use another
tray and call for service.
Fault Code 007-242
Air drive motor fault
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on. If problem persists, use another
tray and call for service.
Fault Code 007-243
Vacuum Valve fault
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on. If problem persists, use another
tray and call for service.
Fault Code 007-290
Internal software problem
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on. If problem persists, use another
tray and call for service.
No power to Tray 4
•
Check that the Tray 4 power cord is connected.
•
Test the Ground Fault Indicator according to the instructions in this chapter.